Activity Stream

"Old stock" can do that sometimes, even though Zinsser products do seem to have a reasonable shelf life. 'Hope the uber-thin coating resolved things...

Mike, while I don't use scoring the majority of the time with solid stock, I have employed it occasionally for something that it was critical for me...

That was likely a very good choice for this application...designed for the task for sure.

There is an adage about a picture's worth in words. From what you describe, it needs no additional words.

Jackie, your chair back came out beautiful. Can you share which dye and stain you used?

I have a very small business, retired from nuclear power been in woodworking since 1982 and yes i have a shop full of displayed projects Where i...

I have an Incra Miter Express sled which I have used very little and a JDS Accumiter miter gauge which I have used a lot. The Accumiter has a clamp...

I feel like I made a mistake buying the incra 5000. It rarely goes on the saw and takes up a ton of room. I should have went with one of the 1000's

Sounds like you might have been ordering lumber for the school also.

Thanks John, I don’t necessarily disagree with what you say about wax. But Odies is an “in the wood” hardwax oil and they specifically recommend...

Hi John, I'm going to use them for small bowls, lidded boxes and some miscellaneous smaller items. I wish I had space to set up a log like you...

We use Vimeo as the online host for our videos to avoid the ads on Youtube and to have more control over them. Works fine. Our current setup is more...

I have a Kreg miter gauge and I use it most of the time. However, when I have a piece that is wider than the distance from the blade to the edge of...

Looks like you are paying a lot for a piece of angle iron.

It's tough to crosscut a 24" or 30" wide panel with a miter gauge, more so if it's also over 4' long. I personally have no use for a miter gauge.

In case you have issues with the one you found, here's the 12V A/C to 12V D/C waterproof rectifier. ...

What an interesting set of accessories. I’ll take both.

The plot thickens… I have sent the laser back and Evergreen is saying that the laser tube is functioning normally and that the problem is not the...

Appreciate the inputs. Given the side cheeks(?) and the bottom edge of each shelf lip have a bearing surface to ride on I did consider trimming up...

Glad to hear it worked out for you.

Thanks all, went with a 35" x 5' aluminum ramp from Allegro Medical Sales. Bill

Don't fill the gap, it is actually an advantage to have a small gap so you can reach around (not over) the blade and pick up the workpiece after a...

In short, Lowes is bidding against a lot of other buyers to guarantee that they'll have mineral spirits when you need them to. Be sure to thank...

I have to agree with the sentiment of no words on the front. On the back, nothing more than, "Brothers, Forever".

The PEOPLE OF THE FUTURE will want to know something about the brothers ,and the kind of men they were. Remember , they are more smarterer than...

I can't remember the last time I used a sled or a miter gage. Cross cuts are done on the Radial arm saw and ripping is done on the table saw. I...

I'll go against the tide and suggest simply 'Best Friends' or a distant second 'Better Times'.