Activity Stream

I found a local "in home" repair service by a guy that worked at my repair shop that closed. Fingers crossed! Thanks for the replies. Patty, that...

I think the answer is yes on both questions. I didn’t replace any screws but it didn’t seem necessary. I guess I should go back in and double check...

I have the 1836 110v and it has been a very good lathe, lots of power, the only thing I have heard people say bad about the lathe is the banjo; I...

Some insurance companies will allow a fire place in a manufactured home but not a wood stove, I believe a stove is safer if used properly, but a lot...

Did you clean each pocket carefully before installing the new inserts. Are the screws all in good shape. Bill D

I have a 2017-build Voyager DVR. I got the Llambrich JK-130-MT2. I don't know if all Voyagers have the same spindle design.

If it helps, i have had the 1524 for three years, I like that the tool rest uses a 1 inch post.

This is simply not what happens at all, once the fibers are cut, they're cut. There is no slicing vs opening them up You do not make wood waterproof...

Wood is Good urethane carving mallet. Over the years, I've had several different carvers mallets. Chris Schwarz has recently been touting his "Lump...

Which is the correct model number for the Voyager?

If it was me I would set up a trail cam once the new pin is installed. Chances are if he removed the first one he'll remove the second one.

SOLD. Thanks for the interest.

Did you realize your post is on Neanderthal Haven? Odd choices of cordless leaf blower and slow speed grinder for a hand tool sub.

I would guess the addition of multiple outlet power bars runs afoul of the limit for he number of outlets on a circuit. I'll go out on a limb and...

A sickening sight staged by an evil idiot….that’s the worst kind ! I don’t think England has death penalty anymore… My statement is , reinstate .

Yep... it's sickening. You can bet the kid did it for his "15 minutes of fame" on social media. He's probably got a selfie of him standing next...

I have the 18/36 as well. Love it. I had a minor issue that I called tech support about (Brian Bennett) and it was handled very quickly... can't say...

Fantastic work Mike. Quite a display of hand tool operations.

It does not take that long. That type of planed surface is called "bright". A sharp plane iron and a properly fitted cap iron are the skills you need...

I have some pictures posted in a dedicated thread as well as some updates at the link below. Basically they're just 20x20 tiles that interlock...

I thought about that, but the Voyager's are currently all on backorder. Most of the added features on the Voyager I would not use anyway.

Tell me more about the floor tiles.