Activity Stream

my vehicles always rusted out before I ran the motors out. Made a rust proof rig and since doing it every year never lost a car to that. The 92...

It apparent you do not have a clue about modern Geothermal Heating and Cooling and don’t care to learn. It’s the fastest growing part of of heating...

Central North Carolina. We routinely run vehicles to over 300K. My 1986 Nissian pickup went to over 500K. Son's 1994 Honda Accord had over 500K on...

Bradley, PM received and answered.

Yeah, 120F was probably too low. Should have said something like 140 or something - although if you set one up with an outlet temperature of, say...

I think some of you guys are missing the point . If someone wants to learn, great. If someone wants to find/hire a mentor, again, great. However,...

I built one using instructions from the now-defunct website bluestemstrings.com, which can still be found on the internet archive Wayback Machine. I...

My parents have two fireplaces. The one on the first floor has not been used in years as it seemingly sucks more heat up the chimney when burning...

Cleaned the router table off...threw out the warped guide strip...plane a new one straight...worked on the Fence a bit....added a 1/4" thick strip of...

Ah, yes. I missed that they were plywood, that would come with risks. I have a helical head and can plane Baltic Birch quite reliably but cheaper...

Finally! Thank you Mr. Schuch! All of the Far Side books have been moved to the bathroom since this thread started. A screen shot was just not going...

I think code requires this if a teenager is living in the house?... or maybe I just read that in the parenting manual that came with my teenager?

Where do you live? My first vehicle was a 1986 Dodge RAM 50... the same truck was sold as the Mitsubishi Mighty Max. It didn't have enough leg...

The neat little General 6 inch 1/32 - 1/64 scale rulers have the decimal equivalents printed right on the back. I still don't know the times tables...

When using digital calipers, which I use often, I do not try and think in fractions like that. I use decimal inches to the thousandth, though the...

My shop is full of great American old iron machines. I bought an Italian sliding table saw that needed some restoration. OH THE PAIN!!!! I have...

For finding centers with the digital calipers I always hit the mm button.

Fresh concrete needs to fully cure...I don't know the answer for that, but whomever does your floor can tell you the expected time frame. If your...

True, if he has a centering support that helps get the longer piece level.

I find it easy to look at a tape or more say my good metal ruler and see its .015 over or its .030 over or. still allergic to metric, did grow...

When I first started turning there was no AAW, no Youtube, no mentors that I had any awareness of (no Google to find them with), no video tapes yet,...

If coloration is hard to see, note the position of each warning mark. In many vehicles, the green is on the bottom, yellow comes on higher and red is...

Carrier example of water to water geothermal heating for buildings and domestic hot water, way above 120 degF , more like 140-160 degF much more...

It does provide visual indicators but I am colorblind so the colors don't convey a lot to me. I'm sure you're right about being able to disable the...

my view bad idea. Logic bad idea. Same thought if I can afford cars I can afford plates give the money to nurses and care givers 45 percent of...

Roger, This might be an opportunity to use that Vega duplicator, but even that would require re-assembling the broken spindle. Drill a hole in...

A lathe could do this very quickly and accurately.

My 26KW generator is about a year old. I just changed the oil and oil filter, air filter and spark plugs, and checked the valve lash. Probably...