Activity Stream

FYI, I am running Office 2019. Works fine for me.

Any chance you could post a picture of your stop?

https://www.youtube.com/watch?v=vNdrkmx6ehI Doggoneit if that's not the only thing I can find also! There's a magazine article he wrote a number...

We switched our land line to VOIP and listed the robo call numbers on their call block app. I found that the three robo callers rotated numbers...

Thanks men. Brian

I have one. The table is slightly larger than the older ones, but the 1.5HP motor is the big deal. I looked for one for a couple years before...

I made a lateral stop for mine, it works great. It's for when one wants to be bang on centre after the pilot. It's more than bang yer head off the...

Thanks for the reply Jim. I pretty much zero to the board as well for most jobs, not sure why so many use material, but that's another topic...

I think you would be better to buy the JessEm router lift for $275 from Lee Valley rather than spending $149 on just the plate.

Nice curvy chair. Reminds me of 1950’s Christmas card Santa sleigh seat . Isn’t that upholstery new?

If you want them to deliver, give them a dozen donuts for break time for the crew, or a couple finished bowls, or a half dozen Christmas ornaments....

You can program the Nova to stop at preset depth but I don't bother going through the extra steps to do that. It is much easier and faster to just...

Scam calls seem to have dropped off for me. The last five or six they sound like they clipped off the intro and just say your service will be cut...

"...which will be followed by a smaller, compact miter saw cabinet since I rarely use that tool, but still want it easily available should I want ...

The lux cutters have a shallower curve (larger radius). The byrd website has a link somewhere comparing the two and specifies the 2 angles on there,...

me thinks these BRAVES and NASCAR blackouts are caused by these 4king CHINA Spy Balloons!!!

Do you still need an explosion proof motor if, like a lot of people, you hang up shower curtains from the overhead, or a PVC frame, forming maybe an...

Nice job! I used to have one of those; it was great for guitar picking.

You need an explosion proof fan, and as I found out when building a spray room, they are not cheap. As for sizing, the standard has been 100 LINEAR...

Here is another option. If the thread is not right buy a smaller one and drill and tap it correctly....

The green compound that Lee Valley sells "leaves behind a 0.5 micron scratch pattern". I think that means it is about 0.5 micron.

I made one with similar width but maybe 14" long drawer face. There was nothing on the sides of the drawer face, just the legs. 3/4" above and 3/4 -...

This plane has been sold.

What are you disagreeing with? Frank's post essentially said the same thing. ". A 20A cord is 12 AWG and can carry a 20A load all day long if it's...

The push button stop nut on my Voyager is threaded. Push the button to get close then turn the nut to get the fine resolution, if needed. Mine has...

I don't have experience with using a larger bandsaw for resawing, but I'm always a bit surprised when people talk about the 14" deltas not having...

Another train of thought. Find a nut that matches the thread on your DP. Weld it into the jaws of the smallest pair of vise grips you can find, then...

Thanks Karl. Figured it must stop off gassing at some point. Good to know about the boiling trick. This was indeed a pretty old tree by my...