Activity Stream

This is on my list to do...so I have a follow up question for those that have used the LV Brad point big. How big of a guide did you bore on your...

Sort of. They do prevent the saw from starting after an outage, but they also have an overload sensor to protect the motor, (which is why they are...

Thanks all for the great suggestions! The depth of my bench top is only 2 inches. I think the bench top drill press is a good idea, but would be a...

Like Prashun, I'd likely do a lot of charitable activities.

Can the top unit be unattached and just sit on the lower? I understand that a lot of 2-piece cabinets are made this way. Mine is.

I’d likely do as Prashun after first making sure there was some kind of structure in place so I would be confident the money would be limited to the...

Always go big with dust collection. You can never have too much. I run a Tempest cyclone from penn state its has a 14 inch impeller with 3 hp...

Both are nice, but I really like the grain patterns in the plate. Please post again after you put the finish on.

I have an Akeda Would like to have it for the fingers which you use for making dovetails Can't pay $300 Shipping to Illinois would cost to...

is the only purpose of a magnetic switch to prevent the saw from turning back on after a power outage? Meaning can i just simply replace with a...

My self and our HOA have used a company that's about $200 more than lowest. A few years ago they took down a 3' dogwood on the park beach.. When...

Looking at the Rex Mill link, it looks to an early type 6 with some type 5 parts in it. The body and front handle are clearly type six. The lateral...

I thought about this the last time the lottery was super high although I almost never buy a ticket. What I always read is you should take a few...

It was like a sponge at the base. I could almost push my finger in. Full of water.

In fairness I didn’t say I was dealing with shylocks. All bids were close and all were long term local businesses, bonded and insured and with good...

Set up some scholarships for people who can really benefit from it.

lol, I'm really not sure if I should take that post one way or another, so I'll say... thanks for the tips! -------- I got the mortises and...

Give most of it away, kids, grandkids, great grandkids. charities. Cheers, Tim

I have a PC trim router baseplate that has two levels. The lower level sits on your workpiece for control and the upper, cantilevered level sits...

Before buying a lottery ticket, you should set up a trust. You and your spouse as primary beneficiary , and your kids (or who ever you chose) as...

Todd, the lines were scored with a knife. These fine kerfs guided a knife when copying them on the tail board. Sawing the marks instead sounds a good...

The first thing I would do is to buy all the working folks around here new stuff to work with.

That looks like a yucky mechanical switch rather than a nice magnetic starter. Check out Grizzly. You can get a real magnetic switch there for...

no one mentioning the depth, its part of the question

That is the title of the thread. The G0490 has a built in mobile base, fixed on the left side and swivel of the right. Until you turn try to a...

Maybe move to a more rural location in a warmer climate. Would probably set my kids up with an income so they could do anything they want as long...