Activity Stream

Julie Moriarty, this anecdote doesn't make sense. If there was a ground fault somewhere, then yes, this could happen. And if there was some other...

When I called Thomas Mwangi to let him know that James and Zelma had been waiting for tech support for a couple of days he told me that one of his...

If you're looking for something thats not a barbecue-style rub, we use the 21-Gun Salute seasoning mix from Trader Joes.

Mine starts in about 3 seconds. Stopping may be 5-7. But you can set it to anything you want. I think I have 5 or 8 seconds on my jointer and a 25...

I believe you cannot get a finish ready surface off any rasp. I find it challenging to get a finish surface using a file which is finer than a rasp.

3-5 seconds would be way too quick. I'd go at least 15-20.

The manual for the water heater calls for 1 1/16" socket. I have no earthly idea why I have a 1 1/16" NAPA socket in my toolbox. None. No idea how...

I think if I went to the city and proposed pole construction, but with sheathing and siding to match my house I suspect they would approve it. The...

The high pitched whistling sound makes me think you might have a missing tooth on the starter pinion or the flywheel. The whistling sound is the...

I have my dust collector below my shop with just the stairwell as a return. (This is temporary.) When the DC is running, the return flow pushes the...

My money is on a bad grounding connection.

I remember it is an odd size, not the same as any bolt head I know of, and did have to buy a socket. It's been so long ago that I forget what size...

An impact wrench has always worked for me. There's really no reason for it to be as tight as they often are. There is no more pressure on the joint...

Ditto on the install ...I paid 5.50sq. ...three man crew and some serious dust collection equipment for the grinding process.

Thank you. That's very helpful.

It's all good. I haven't ruled out a SawStop, but right now I'm looking for information about the Harvey. :)

Not sure if this could be the problem, but sometimes an engineer will throw in a left hand thread just to mess with people. Or some idiot in...

thanks on both. Makes total sense as a starting point. Bit hard to explain well as it was still trying to turn over that is it was moving a bit...

Funny how they always seem to pop up with an answer to a question that wasn't asked isn't it?

You might want to look at the Polyaspartic coating for your daughter's new garage. You can do it yourself and all indicators are it's far superior to...

You want 3 wire control, that diagram doesn't appear to show that.

I’m also open to trade Hand forged axes - Hoffman, Kalthoff, Karlsson, Lonon, etc Pfeil bent gouges Veritas grinding tool rest, tool rest jigs ...

Jeff to be honest I have no idea what under the slab. During construction I saw a grid of trenches dug down several feet. 4-5 feet u guess. Inside...

When I worked in a shop that had both a track saw and a full size sliding table saw I would have received the side eye at best and more likely a good...

First, whats your budget? Is your business stable enough that you are comfortable financing $25,000+? If your budget is only $5,000, then you can...

thanks I just ordered a set of three.

Looks like you are dialing it in. The shop machine layout probably got more mental percolation than any other part of my shop. I already had a...

Do not forget the ground terminal, both ends. I carries just as much power as the hot lead. Bill D.