Activity Stream

Try finding that meter when it's covered in snow. Good luck! It's the same with hurricanes here. When one is even remotely predicted to affect us, I...

I have many Kreg tools and I have also had great customer service. I wouldn't hesitate to buy their products in the future.

ive used most of the sheens. I like satin. ive finished a number of projects right on the lathe. It’s easier to avoid runs.

I would find a scrap of oak and repair it with oak.

Go to Lowes and Home Depot, fondle their knives and you will find one.

Gone! Thx Harold

Milwaukee Fastback Folding Utility Knife, 48-22-1501 LINK Best utility knife I have ever used. Easy flip open. Never sticks. Easy to close....

You can get Mohawk Finishes "Shellac Reducer" which says on the can that it is a denatured alcohol "blend". The SDS states that the "reducer" is a...

Are you referring to a switchblade or “flip knife”? In some jurisdictions those are illegal to carry on the street. (I’m talking to you, NYPD. Y’all...

Most of the places I have used have been mentioned, another is Monteath in Sayreville. Mostly domestics, tend to think they are on the high side but...

This item has been SOLD

You will get little consensus because there's no "right way." You will be tempted to buy lots of gear without fully knowing when or even if you'll...

Boards and Beams in Fairfield is decent for hardwood lumber. Their slabs are pricey, though.

We have no basement. Concrete slab since we live right on the coast. Agree with the sub panel in the garage. Right now we have 110/20amp service....

I wish my first piece looked that good ... it was a fairly hideous red oak nightstand, which has long since been dismantled and repurposed into...

I set it up how it said in the directions. Place a straight edge so it's just up against the cutterhead. Still get a bit of snipe.

I see several on Amazon with the label "Poly Whey." Do you prefer the satin, semi gloss...?...

The cherry desk I built for Professor Dr. SWMBO in 1997 (my first project, actually) uses this same general design, although that one would be...

Then it is just the lens/photo angle. Mine are 18” square also with 2” overhang. It’s one of those pieces you really grow to appreciate!

Thanks, love the shop by the way.

Never used it on a turning (interesting idea), but VNC is the finish on the floor of my shop and it’s great in that application.

Surely somewhere, someone has made a YouTube video with hydraulic jack equipped with a pressure gauge breaking dovetail joints apart in both...

Tim, Sorry to hear of your unplanned hiatus from woodworking. I put most of my tools into storage for 5 years when I went overseas. In addition...

Best one I've ever had - perhaps the same one that Bernie referred to: $8 at Home Depot.

I'm not going to do an actual count, but it's a reasonably high number when you count furniture, decorative things like picture frames and other art...

Much good info in here and I will add my firsthand account as well: 1.) This was truly a "Once in a century event". Here in Central TX, we get one...

Been that way in the San Francisco bay area for about 10 years. No one comes to the open houses they jjust watch o nthe internet. Sounds like you...

My Bose system consists of the head unit, power amps and speakers. I'm only going to change the head unit. But something Bose has always done is...

For the leve or work required, have a small sub-panel installed so you not only get 240v for your intended table saw purchase, but so you can also...

Thank you, Ron! Thanks, David! Thanks, Jim! And you are correct, it's very adaptable. With all the work from home situation, I am...