Activity Stream

I can't seem to find any of what I guess might be a unicorn, in regarding the best CO what's out there, but I can see ones point in looking for one...

What material is the table? If it is MDF or plywood, I would just glue in a hardwood scrap and recut the dado. If it is cast iron, you could use UHMW...

Pete, I’ll take them if they’re still available. PM sent.

All narrow crown staples. panels are 3/8" plywood, bottom is between the sides.

Good interview. https://www.youtube.com/watch?v=x1FfVOG1MVk

I'd wrap some veneer around a form instead of fighting with the 8/4 stock and doing all that turning. You are also going to get some weird grain...

I know, I looked it up. That's why I concluded it's a hybrid style machine. There sure aren't any chips when sanding!

Thanks Glen & Chris!

That is a very nice piece, plenty of balance and best of all fitting for the purpose intended. As for the paint finish forget it! The the target was...

Good information about the silicone, but I am specifically looking for a way to avoid refinishing the chair. I just want to make it look a little...

Sold thank you….

Nice work Julian. Really easy on the eye. Thanks for sharing.

45 degree frog

I was introduced to the Robo Sander at the mandolin factory. The Robo Sander can do things that a router can not, slowly and at the expense of lots...

That is what the parts are called in the manual, :rolleyes:

Very nicely done. Thanks for posting.

I will add that to my list. Thanks.

Sorry missed your post there John You get me wrong, I've been much longer spending time Centaurolizing my solid wheel ACM machine, which did lend...

Restor A Finish would probably even it back out enough. It's made me look like a genius more than a few times. The newer Restor A Shine also did...

Looks more like oak than ash to me, but it's irrelevant. Putting Pledge on it made any finish repair work a lot more difficult. That stuff has...

Just curious Jeff, what is the bed angle? jtk

YOu can purchase glass discs from McMaster-Carr i 1-3/4" dia x 1/8" thick. This person will custom cut glass discs Scroll down the page to see...

Wow, the SWAT expo! That’s a blast from the past. We (Minimax USA) did one of their events in the mid-2000’s. It was located in Wichita Falls, TX at...

Depends on ones perspective, I suppose. I've seen and experienced damage concerning wheel bores, along with mentioning the Far Eastern design which...