Activity Stream

In a word, yes.

Shims have been bought. Monday has gone away. Tasks for today in the shop.. Run a round over bit along all the edges of the ladder...

I got my 6" DWV PVC 45s from Amazon and wyes from Menard's. Menard's has 45s, too. PVC works great, you won't regret it. Unistrut on the ceiling...

Check the weight of 10' of 6" PVC. Given the weight I plan to use shop made brackets and metal strapping this time around. This will get me...

I suppose it could be. I only know the routers that I have seen in HD or Lowes. This thing is a beast compared to those.

That’s sad to hear about Sawstop. I haven’t had any issues for years so I haven’t called them since they were bought by Festool. I thought at the...

I had a router like the Ebay listing, that model has 2 issues. One is that the cooling fan on the motor shaft tends to shed blades which causes lots...

Call them and ask if the part is actually in stock? I'd assume they probably just drop ship from Grizzly anyway.

I will do that now. This was my first post - I have only been a lurker until now. :o

Even without planing past the top sheet, the veneer will be thinner on one side and probably lead to more warping since the panel would become...

Darned if I know. For a long time I made my router table plates from plexiglass. I can’t really recommend that because the plexiglass tends to...

Help a new woodworker get started. When I upgrade & determine a tool is no longer needed - I gift it.

Yes. You are looking for D-2729 or SDR35 connectors for fit your D-2729 thin wall sewer and drain pipe. You do not want Schedule 40 as the dimensions...

That'd be my choice. Mechanical joint and maybe epoxy though TBIII would be cheaper. I'd also beg to differ that biscuits add NO strength. As much as...

I was doing some freehand routing once and there was just a little bit of vibration. I found it sort of handy. I was able to move the router with...

No Molotav's here either Kev :). I think you are talking about managing debt as part of your cash flow and overall 'plan'. The OP and I are talking...

A report I saw last night on the news was that lumber prices could be expected to normalize next summer. What will be normal?

Derek, this is awesome. Thanks again for sharing. Erik

Dave, I honestly thought it was 3%. 6% is news to me. Erik

If the link is taking us to the right place this may be a matter of perception based on experience. The router in the middle is about the size...

Yep, the roll stuff works well also. It may be 'wet' a while after you laser, but it dries quickly.

I was considering PVC for my ducting, and thought of using aluminum foil tape as a charge drain. Just run a strip down the outside of the pipe;...

This is where I would be... if a problem, then deal with it. Personally, I have 3 hp dust collector and 6" PVC and have never been zapped (knocks...

Sending PM.

I would use Titebond 3, If I was really worried I would join the pieces with a 1/2" x 1/2" tongue and groove. This would add a massive amount of glue...

The price of the Ridge Carbide blades has been lowered to $105 shipped. PM if you want the set.

Here is a pretty goo video for aligning your band saw table. I followed this procedure for my 14" band saw and now drift is a thing of the past.

Very nice. A clock is on my list of things to make. You set the bar pretty high.

I bought the setup from Acme and so far, they’ve been the best tool seller I’ve had to deal with when it came to problems. I called yesterday morning...