Activity Stream

I use Firefox on my android tablet and have no issues viewing all the pages. You might want to give it a try.

I find this useful. It is a Klingspor badged Bosch 1295.

Not sure I would go horizontal with this type arrangement. As others have mentioned, you would need to deal with the particulate that gets past the...

Justin, is your father a woodworker too?

Some panels have a back fed breaker on the branch bus as their main. It has to be mechanically fastened to the panel so it can't be pulled out like...

Kris I seen your local Craigslist ad. Good luck with the sell, if I had that kind of disposable cash, it would be tempting.

I believe full site, not a fan of mobile view

I use a Bosch 3283 DVS sander (I have four of them of which two are still operational) to sand narrow surfaces and I think you should be all right if...

What Jim said. Also, I've ganged multiple small pieces together with some scrap of same thickness at the edges to balance the sander. I've used...

In addition to Mark’s excellent suggestions, which direction is your circ pumping. Is it “to” the close radiant loop to the circ. Perhaps I missed it...

A frog goes into a bank and approaches the teller. He can see from her nameplate that her name is Patty Whack. "Miss Whack, I'd like to get a...

Thanks, John. Is the bed the same as the sole? I did flatten the sole, which I forgot to mention above. How should the screw on the cap iron be...

Matt, I'm very interested in an Avid Pro6060 (don't know if that's proper model number, but I'm looking at a 5'x5' setup). Actually a 5' x axis, 4' Y...

I assume you have the blade in correctly - bevel to the rear? You may have too much blade exposed. Wrong angle on the blade - 30* works for me. The...

I don't remember how I got it back in when I finally hauled it to the dump. But it had rotted to a little lower weight by then.

Todd, thanks for the information. Did you have to modify the dust rite box much? I see you have to drill a hole in the side for the height...

Tips on how to clean up your shop/garage:...

I would also be interested in purchasing a thumb drive

The wild hackberry is a very fast growing tree, with an average lifespan of maybe 30 years, towards the end of which it bestows gifts on the...

My opinion and my practice whenever possible is to remove the burn marks, either via sanding or with a scraper and/or a hand plane. A stain blocking...

I have a 14" Rikon and, although my stock rubber tires were still ok, decided to upgrade into polyurethane ones which I kept reading about. First,...

In the grocery store today, gentleman in front of me told cashier "If I had my check already, I would be buying more groceries. He said his showed as...

The Emerald Urethane is reported to be an excellent project, but it's been said that there may be a slight amber cast due to how it's formulated. If...

Over on the shelf, with the rest of the bench planes....is a No. 1414 Hercules..by Sargent...price tag said $12....hmmmm.. Sitting beside it is a...

It's a 2 part epoxy putty that comes in some limited colors. You can use it to fill voids, either natural ones or inlays you make your self. Once...

It is attached with two peg board hooks that I straighten slightly so the were at 90 degrees and inserted them into holes in the upper cross brace. ...

My Oneida is similar, but instead of a small bag, it's a small steel canister that clamps on the bottom of the filter. There's rarely anything in it...

Afraid to look inside mine.. Behind closed doors? Tooth line is vertical....you have to raise a saw up, to release it... Before the stain...