Activity Stream

Tesla draws 30A, but I won't be using the charger when I use the power tools

That's a very low number. Why so low?

Which direction does the door face? Is the door on the front of the house or side? Wayne Dalton doors are the most common and their medium to top...

It's that short cross cut distance on cabinet saws that prob. has many of us always considering a sliding TS. I did not realize the SS blade to edge...

How much does the Tesla actually draw? You are getting into the realm of needing an electrician for many reasons.

These things can be triggered by cooking (water vapor or organic, fat etc into the air,) or even by running a humidifier; the effect can be...

I've never been successful in wiping off dye. Planing or sanding is the most efficient (assuming you haven't otherwise sealed the dye in with a...

it's 2-3/8" so assume 4-1/2. 5-1/2, 6 and 7

I generally use 1k as my threshold, for the pro model the 'fair' range is from 300-1050 for the .5 micron reading. What is interesting, is that...

Some creative spirit should 3D-print a snorkel that replaces the entire factory plastic piece and integrates that magnetic flange. As many A3 owners...

What size plane does the frog fit?

Warren, I agree: Mobility bases on sliders (or any big machine in general) are generally a hard "no" in my book but everyone has their own mojo. This...

Hi Rod, the upstream of the outlet is a 50A breaker, if I replace the outlet with a sub panel, with a 50A breaker for the tesla charger and 2 20A...

PM send for Left and Right skews.....

I have four of the basic units. When I got them I don't think the larger industrial model was available. Two are over my widebelt sanding area, one...

keep the improvement thoughts coming. Isolation between concrete and metal is a good thing. Personally I cant stand the look of moveable bases...

Hi Fred, A picture would really help to see what you are doing. It took me a few readings to visualize a tail in the center of the joint with two...

Thanks, Brad! David

I'll PM you!

I was just browsing the cherry at Irion lumber in PA and they probably have what you need. Sounds like a fun project.

How high do the numbers have to be to cause you concern? What's the threshold for putting on a respirator?

I have 1.75 now and it is plenty for me. Do you get better features by going to 3hp?

Taking a cue from a youtube video on the A3-41, I'm trying the Rockler schedule 40 to 4" adapter and their quick fit adapter stacked on each other -...

Can anybody measure the table post size of any Grizzly or Shop Fox floor drill press? The Harbor Freight 13" and 17" both have the approx. 1.85"...

I have one somewhere. If I run across it, I'll send it to you. I don't anticipate ever having a use for a folding one. PM me your address. No...

I don't have much to add information wise, but I also have the 1100 pro, and I am very happy with it. It was quite surprising just how much...

Not trying to get personal if you were directing that towards me, or was it Erik for his comments? Thought I was discussing and asking a question...