I have a jet 1 1/2 HP shaper for sale in North east Iowa. Hasn't been used much, things just didn't go as planed. It is in almost new condition. Runs...
I have a legacy ornamental mill for sale in Nashua Iowa. It will do all the twists and fluting on any kind of table or poster bed leg I can't begin ...
Not to rock the boat but I would pay the $150 to have it jointed and planed for me. There is some, but not a lot of skill required in running boards...
1. No requirement to make a cut anywhere, but one could. I set my crosscut blade between 1/16" and 1/8" deep into the sacrificial top--no need to go...
I have "quite a few" old backsaws, and often move the back to re-align with the toothline, or remove the back entirely in order to clean the rust off...
A good quality table slide will support the table by itself. No problems. I used a steel and ball bearing expansion slide with 2 leaves. A good point...
Josh, this design from Nicemac as outlined in the Festool Users Group is the design I plan to follow when setting up our Festool Kapex miter station...
