Activity Stream

Lets see...parts planed flat, edges jointed.. Tools to do a bit of layout, and the first lay out done.. Saw a few lines? Chop out the...

Any kind of fence posts can last a long time in a very dry climate.

you know if there wasn't enough glue that might explain the delayed leak. it may have held until someone got to rockin :D

I looked closely at the upper right corner of your coupling photo and I don't see any glue. I think it's harder to get good coverage of glue on...

Steve. I second Jim. I’d call Harvey. They didn’t charge additional shipping when I called and ordered a shaper with a sliding table accessories. As...

Yeah - if I get the 20' I will also need to pay $100+ for their delivery. I was just looking at the pergola kits at HD and their long beams have...

Where I live the coaxial cable shield must be connected to ground where it enters the house, part of the Canadian Electrical Code Part 2…..Regards,...

Sold to Doug!

Send it my way please.

According to the user´s manual for my Makita bandsaw, slower speed is for metal cutting. Higher speed for wood.

easiest fix is to take the toilet up, cut the top of the flange off flush with the floor or a little below, and use one of these: ...

Very nice. Looks like it will work well

It's sometimes possible to seal leaky PVC drain joints by applying primer to them.

I think the concave surface is usually from planing dirty wood . You know ,boards that were first into the truck bed sand pile. Old timers I worked...

snowload? Might as well angle the roof and make it a solar collector Bill D

Japanese hand planes use 2 different patterns on the working surface, one for truing and one for smoothing. They definitely not dead flat. Western...

Dude...I'm already thinking serious about that since you originally posted about it! LOL

I didn't bring up Shiraz, Earl did.

16 foot car trailer back up close then lift the trailer tongue and put it over the ball and lower. You can also drop the tailgate and have very good...

A 20' 2x8 will almost sag under it's own weight. 2x8s with a half lap and no post will carry little load as well. You're going to have to give up...

Thank you all for the ideas. It's a brand new toilet which I assembled as per instructions, but the wax seal didn't have a rubber sleeve. It seemed...

Might be a silly question, but have you verified your straight edge is straight? I wouldn’t think all of those planes would be out of flat given the...

If you separated the bowl and tank, did you put a new tank seal back between them? Make sure floor is dry, and lay a piece of newspaper behind the...

To the best of my knowledge it is not a design element. It may have been caused by someone trying to lap the sole without knowing what they were...

What sort of load will be on these 20' boards? What is the cost of 2 x 8 x 20 shipped in for free versus the cost of doubled up 12 footers?

I pull equipment trailers with pintle hitch all the time sill no problem.