Activity Stream

I have found the toothed blade to be useful for stock removal. Added benefit is that it makes great packing material for wine boxes.

costs a bit more though.

The April 2020 payment was direct deposit.

With the LA Jack, my view is that 2 blades are necessary: a 25 degree for shooting or planing end grain; and a 25 degree + 50 degree micro/secondary...

I used the LV dog hole guide bushing as well as their BP bit. IIRC, the guide bushing presses into any board at least 1.5" thick. I had a chunk of...

A magnetic switch would be a simple relay. A motor starter is different and serves a few purposes. Thermal overload protection being the primary...

No offense intended. Looking back I see in your third post you said you were building Chris' bench with tips from Marc, but I missed/ didn't track...

Nice jig for an auger style drill bit for 20mm holes, https://youtu.be/M-NWq7j3lEw?list=ULQ6wigW_VX54

I only play if the jackpot is 100M or more. For this go-around, I bought twice from the Kroger (Novi, MI) that sold the winning ticket (but not for...

My post assumes the overhang is sufficient to direct the water out of harms way, Some houses have very short, 6-12" overhangs. Others like mine...

This is on my list to do...so I have a follow up question for those that have used the LV Brad point big. How big of a guide did you bore on your...

Sort of. They do prevent the saw from starting after an outage, but they also have an overload sensor to protect the motor, (which is why they are...

Thanks all for the great suggestions! The depth of my bench top is only 2 inches. I think the bench top drill press is a good idea, but would be a...

Like Prashun, I'd likely do a lot of charitable activities.

Can the top unit be unattached and just sit on the lower? I understand that a lot of 2-piece cabinets are made this way. Mine is.

I’d likely do as Prashun after first making sure there was some kind of structure in place so I would be confident the money would be limited to the...

Always go big with dust collection. You can never have too much. I run a Tempest cyclone from penn state its has a 14 inch impeller with 3 hp...

Both are nice, but I really like the grain patterns in the plate. Please post again after you put the finish on.

I have an Akeda Would like to have it for the fingers which you use for making dovetails Can't pay $300 Shipping to Illinois would cost to...

is the only purpose of a magnetic switch to prevent the saw from turning back on after a power outage? Meaning can i just simply replace with a...

My self and our HOA have used a company that's about $200 more than lowest. A few years ago they took down a 3' dogwood on the park beach.. When...

Looking at the Rex Mill link, it looks to an early type 6 with some type 5 parts in it. The body and front handle are clearly type six. The lateral...

I thought about this the last time the lottery was super high although I almost never buy a ticket. What I always read is you should take a few...

It was like a sponge at the base. I could almost push my finger in. Full of water.

In fairness I didn’t say I was dealing with shylocks. All bids were close and all were long term local businesses, bonded and insured and with good...

Set up some scholarships for people who can really benefit from it.

lol, I'm really not sure if I should take that post one way or another, so I'll say... thanks for the tips! -------- I got the mortises and...

Give most of it away, kids, grandkids, great grandkids. charities. Cheers, Tim