Activity Stream

John, No luck finding my cut settings for the above posted pic of .125 thick 360 brass. Seems like .005 doc at 40 ipm is about right. I usually...

Mike Farrington on YouTube has a good video of his overhead blade guard.

I'll be glad to get it. I thought it was long gone. Getting ready to leave right now though, but we'll be back tonight. I sent a PM. Will be back...

I’ve had a 17-950 for years of hobbiest use. Never a problem, just hate changing speeds. You got a great buy.

The Bosch edge guide is pretty darned nice, and i'm seeing it at Amazon for a little over $40 right now BOSCH RA1054 Deluxe Router Edge Guide with...

That's exactly what I'm saying, Derek. They worked for Jim and they should work for anyone who follows Jim's methods, which are predominantly...

Oops, it's part 181 that slides up and down...182 is the shaft.

It is possible that the blade you have on it is too long and the tension adjust is at the limit of it's travel. I had this problem on my 14" Delta...

I’ll have check that out Tom, but have another question. These windows came out 1948 Home and few sashes the bottom rail and where joints to styles...

YES YES YES, I think it could be frozen! I'll investigate again. Thank you kindly, Linda

I believe the tab that sticks through the oval opening is supposed to move up and down (therefore pulling on the cable, which I think just goes to...

to check for 90° I just use a good 12” metal ruler and clamp it on edge between two spacers on the spindle then measure with a dial micrometer at...

Interesting idea - had thought along those lines. - Thx.

Having been fortunate enough to have spent more than a few days in a traditional house, sitting around a blanket table. I agree. There are cultural...

Well that was interesting. I broke a new O-flute bit using SpeTools' recommended speeds, feeds and doc for brass, and then another at half the...

All the Japanese tool stuff is the rabbit hole to end all rabbit holes. You can respect other traditions (in woodworking, food, and lots of things)...

Reading many of the above posts led me to ponder on the OP's original question. One thing came to mind that hasn't been tested yet. It would be to...

I don't see anything on the exploded diagram or parts list for whatever the wire thing is attached to Part #184, the tension tab. Not sure what...

Ok...did you notice WHERE Mr. Dupont resides? Compared to where YOU live...hmmm, must have missed that little bit of info?

Thanks for the kind words Stew. In a previous post a picture of a wooden outboard sole was shown. This was my first attempt at making such a thing...

FYI Several years ago Epilog had a serious X axis motor issue which they dragged their feet on resolving. My recollection was that they had used a...

Well that's one mans opinion, I personally find is offensive to criticize what others believe. The Japanese to this day still preform a Jichinsai...

To get spindle 90 to the table look for "tramming a bridgeport head". Make up a bar like the photo from ebay but the center hole large enough to go...

Kev Have you tried Main Trophy? https://maintrophysupply.com/

Full disclosure - I am the Tech Support Manager for YoraHome; would have responded sooner, but took a bit for approval in the forum. The...

I have to donate again to see the picture posted. I wish there was a multiyear option. I assume the post is the reference to the fat it says it...

If you're going through the effort, I would be inclined to try and have vertical as indicated on the machine be in fact vertical whether by adjusting...

Have you experimented with the hertz setting in your materials sheet? A higher number will produce a smoother cut. The software automatically...

And because this is a tilting machine it's really only important to have the spindle in "in tram" parallel to the axis of the tilt. The...