Activity Stream

Sorry about my mistake Si! That split pin looked like a set screw to my old eyes. Good luck!

Yeah, I thought the same thing when I bought mine Andrew. Even though they state the dimensions and show a picture, you really just cant visualize...

The lever quick release was sold seperately to be added to the clamp. I had some, found them to be a knuckle buster, gave them away.

It is so handy that I just bought my 2nd one.

I've had really good experiences with General.

After thinking about it, Harvey's motors may actually still be AC. It isn't clear. Does anyone know for sure? These may be the way of the future. ...

What is the correct range for this? Has anybody ever burned up a motor because of clogged filters?

Sounds like an additional selling point for whenever we sell the house (The EV charging point). I think I will be doing all of the digging on this....

Thanks Leo. I've found it on Amazon. I have to check for parallelism of the blade to the miter slot first. I gotten a lot of good advice on this...

That's a pretty long distance. Did they work with garage doors open? Crazy to think about where else the spray went.

I thought that it was off on ONE drawer.

Worked at a place that had a model/pattern making building and a fiberglass mold making building. About 80' apart. If the pattern shop used silicone...

If using 2” pvc conduit a 24” trencher is fine as you only need to go down about 20” (2” conduit + the 18” required depth). If direct burial then you...

Have you considered the Rikon 70-3040? Seems like a real space saver.

PALS = "Precision Alignment and Locking System". Sold by Peachtree Woodworking, among others. Search for "table saw pals" on Google or Amazon and...

Glenn, I had the wrong number. Correct model number is 113.29901.

I looked at Oliver's new lathe. It's hard to beat Oliver's reputation and the lathe certainly is built "like an Oliver". However, the controls...

Interesting story, thanks. That would be pretty crazy if waxing a car near a paint line would affect the whole operation. Not sure I buy into it...

When you look at Grizzly's history and posts, you have to also consider that they probably sell far more lathes than anyone else. So it stands to...

If you run the wire yourself, dig the trench before buying the wire. Measure carefully, and get enough to have some to throw away, or you're sure to...

on the metal working side, it looks like they are really a few steps up from the griz versions. heavier, more features like auto feeds and DROs and...

Years ago, I was privy to a story of an auto manufacturer that had an Indy car show up for employee motivation. The car 'steward' (baby sitter) got...

Yes, standard blades fit, and there is plenty of room in the easily opened, but stays closed while using, handle, to store several more in a...

I have purchased from them three times. PM me for feedback...joe

Sorry, Richard, you are wrong on the Grizzly. Must be thinking of the old ones. New ones have none of those issues. Banjo is every bit as good as...

I did that myself for the 250' to the shop and more recently about 650' to a new building site and 400' for another line. I have the equipment to...

My other one is red, Lee. I got them at HD and they had both black and red. The belt hook sometimes comes loose and since I don't use it, I remove...