Activity Stream

Most used is my DX60. Very comfortable and weighty in the hand gives me alot of control

I haven't been an Executor in Virginia or North Carolina since 2006, but it was required then to run a death notice in a local paper, and give notice...

Rather than buy ready-made frames, I just used pieces of 1/8" by 3/4" aluminum bar stock from the home center for these. The notches were setup to...

Tighten the motor pulley set screw

I've never seen anything like that around here. A heat gun is the fast way to remove paint. The main tool I use with it is a painter's 5N1 tool...

I frame for 2 local artists, most in poplar, oak or maple. I tend to use whatever glue bottle is closest. Here is the clamp that I use. I have bought...

Perry, not many "death notices" get to the almost non-existent newspapers these days, especially since they cost money to the family to post them....

You can certainly post a "Wanted" in the Classifies here if you upgrade to Contributor status. Folks are not allowed to offer up "stuff" in the...

Needed a nice wide, flat assembly table... But, this will work...clamps were laid out.. Some within an arm's reach, some were a 2 step sort of...

Favourite plane has three categories in my shop. The most used workhorse, the most fun to use and the one that does what no other plane can do. My...

Have you tried using the OWWM forums?

Hi David, go to turnrobust.com and find the toolrest page. There is a video that will probably tell you what you need to know.

Currently in use.. Stanley No. 71-1/2 Router plane Since I was chopping out 1/4" wide Stopped Dados....in Ash

Lee I normally build drawer boxes from 5/8" material, curious if you used 3/4" on this for the extra support? thanks Brian

Glenn, what are those clamps called that you used on the box, and where did you get them? Thanks

I am not familiar with rd-works but can offer some Corel suggestions that can assist in exporting a Corel image to another format.. 1 have a look at...

Its a pretty narrow gap (maybe 0.005") across the length of the joint from inside to outside corners when looking down on it. The wood is curly...

Thay are at U of Tenn too. I’ve watched them waiting “patiently” at crosswalks until traffic is clear, and going up a sidewalk, suddenly halting for...

Grubhub has started using these to deliver food around campus over at Notre Dame. It's kind of weird watching them scurry around.

If you have a pro-size hollower, the size of the cutter is Ci3. The mid-size uses a Ci5. I don't know the difference in size, but I assume that you...

Current favourite is my Custom LV #5 with a 55 degree frog, since I’m working on dastardly tear-out prone woods for my latest project. Agree with...

Foley Belsaw made the older sears planers. I think yours is too modern for that maker. I know it is too young for the Parks planer sold as...

I was impressed watching the video and sent the link to several friends. Today, one of them sent me a reply showing that U of M here in Michigan will...

hahaha... that is great! :D