Activity Stream

Another non Dentist but I had a tooth with an old (probably 10 year old) root canal that was part of a bridge supporting a false tooth (not sure if I...

Tire rim sizes are in inches, though the tire diameter may be metric, as well as the width.

Peter, I didn't have time to read all the responses so maybe this is covered. Once a MT spins it can gall both the MT shaft and the socket and...

Tyler the original post is about 11 years old !!!!

After suggesting jatoba earlier today, coincidentally I actually turned some today, and after seeing it up close, was surprised at the size of the...

No matter what kind of bench, it is always good to have the top overhang on all sides 2-3" to allow clamping work to table. Marc

I'm not a dentist, but have been on the receiving end of a couple of successful root canals in teeth with a crowns.

I used olive. Our personal chef uses it all the time in the kitchen. A poor cell phone pictures with lousy light, but maybe you get the idea. ...

Might depend on the use. I have some specially ground NRS that are 1/4" and one that is 1/8". These I use for special purposes such as small detail...

I took the liberty of rotating the picture for you. I want one of those too. I have so much work to do up high I'd use it every week. I...

Or try Glacial Acetic Acid. It's essentially strong vinegar. Mike

I agree with that. I replaced several problem toilets with Toto toilets and never had a problem with them. Mike

Scott, PM-V11 really does live up to its "hype". As fine an edge as good high carbon steel, and twice as enduring. Regards from Perth Derek

Yep, I learned a long time ago that a realtor is working for herself or himself, not for you. During normal times they will try to get the seller to...

I like edges broken a tiny bit and use a block plane for a small chamfer on corners as above. Depends on the wood and how much it will get banged...

I will try the Simple Green. I just ordered a 10 yard roll of 80 grit Abranet from Amazon. We will see how that works. It is the Mesh Grip. It looks...

I know that cats are choosy, but I'm thinking that maybe a nice piece of 3/4" CDX or some T1-11 might prove to be better suited for the task... ...

I have an extra 1/2-24 acorn nut to match. I was restoring the same model jointer and needed one so I had my friend who is a machinist make me a...

That's a really nice looking inlay, Roger! David

Thanks, John! It was a fun project, indeed. David

Hey Tom Hope you get one. I just watched two small ones sell that go to 35 feet so they say. Ive grown white cedars and white pine from...

I'm planning to move to a town 125 miles from here this year or next, and become a homeowner with a home occupation there. I'm going to need to find...

Always an issue being the first to respond, all the details haven't been explained yet.

What would be the advantage to moving the bed a little? I am asking because I don't know, no offense intended. The way I have it set up the iron...

I like O1 because it is easy to sharpen. I like A2 (at high bevel angles) because I don't have to sharpen as often. I have my first PMV11 iron on...

I recently purchased a motorcycle lift table based on a recommendation from someone here and it has been one of the best additions to my shop. Mine...

Thomas, Sorry, just saw this post. Yep, ~2 hrs to Atlanta. Maybe 2.5-3 to I-40W and the mountain trail. I coop'd in Oak Ridge (Y-12) when I...