Activity Stream

I use a clamp-on amp meter. If not familiar, these are actually "clamp around" meters. I clamp around the individual conductors at the breaker. ...

Regarding that Nova 1624, Teknatool may still have some DVR conversion kits left. It consisted of a new motor and controller if i recall...

I don’t see your location noted. But the stuff doesn’t work well in the cold , and really isn’t a permanent type adhesive. Inside it usually lasts...

Woodpecker offers the PRL 2. I have the original version and am very happy with it. Can easily dial it to the exact height needed. The newer one has...

You can start looking in...........https://www.coloradoheirloom.com/wood-strip-br/-6-x-24-x-br/-1/16-3/32-1/8-3/16-or-1/4.aspx

Sent you an email.

I use threaded inserts in exotic woods for bottle stoppers. Best installation for me is using the matching bolt with double nuts (locked against...

I got the Arno sharpener today. What they call the v-shaped carbide insert is quite sharp. I tried it out on pocket knife extremely dulled with...

You're welcome. I wish I knew the whys and chemicals to be more helpful. Just another point of reference, in the Maker Space rules there was no...

That's what my gut says too. I've never edge banded anything before. Is it difficult?

Husband pulling out into traffic: "Hey, any cars coming? Wife: "No" . . .

Where are the pins — inside the finger hole? You could use brass pins, and nobody would ever notice. Brass escutcheon pins are readily available.

I've never tilted the table on a bandsaw. Those times I need an angled cut on the bandsaw (or the drill press) I just rig up an angled plywood...

Eric - I used the UPS Shipping calculator for a shipment to Nashville. I come up with a ground shipping cost of about $120 or so. Plus, then you...

I like using my router and an edge guide. Always nice and repeatable. The toughest thing for me is setting the depth just right, just a hair deeper...

I used to use bucket traps at my cabin and got tired of emptying the nasty, stinky water and mice slop. I switched over to PVC bait stations. You...

A really good set of linesman pliers like the Knipex 0912240...

Yup, I was going to respond with Patriot Guard Riders. I rode several missions with our local PGR group. It was an honor to serve in this capacity.

Depends on the laser-- Polycarb under C02 laser will resemble plex engraving, mostly clear, but polycarb gives off a thick yellow smoke that...

I bought a donut CT & digital display for my DC that was shockingly inexpensive and quite accurate. You'd need 2, 1 for each line. I think it was...

Thank you David. I thought it might not be good to laser, just couldn't really remember. I know vinyl is a big no no because it can be caustic to the...

Need a choice of "DEPENDS"... sometimes yes, sometimes no...

I'm not an experienced user and I don't know much about the chemistry of materials. I do clearly remember our Maker Space's training included a list...

I have a Rikon 10-325. I use a "Y" connector with a 4" port connected to the machine's 4" below and a 2 1/2" flex connector from the 2 1/2" of the Y...

I have a customer who wants me to engrave acrylic glassware. She said they are a polycarbonate. I've engraved acrylic that was most likely a ...