Activity Stream

Brad, I will take literally ANYTHING over stepping on a lego with your bare feet. ANYTHING. Erik

+1 ^^^ I always assumed it was just a matter of physical size of the chile. How would you peel something like a serrano or jalapeño? That being...

My thoughts: -Get as long a sliding table as you physically have room for. I have never had a customer complain about having too long of a slider...

Nice, stout looking machine! A lathe is one of those machines that you find so many jobs for that you wonder how you managed without it. That is...

That happened to me with a brand new LV plane. It was like the first scratch on a brand new car - made me sick. I did not try to remove the scratch....

M12 driver is SOLD; M18 brad nailer is still available @ $165 shipped, like new condition

So, all the local refinishers have blown me off after seeing pictures of the chair, so it's clearly my project now. The good news is that the finish...

Robert I have gotten where I use mine a lot. Saves a lot of time sanding which I hate and it works great on those occasions where I get talked into...

A deep scratch is bit harsh. I call it a apprentice mark :) I pretty sure all my planes have them. :o

Also, lifting that 24x32 cast iron table about gave me a hernia.

What kind of surface finish are you getting? Reminds me of my lust for a Mori Seiki 16x50 a few years back but just too large for my 3 car garage....

My first thought would be to leave it alone if it isn't leaving a mark on the work. This could have been caused by a piece of stone or other grit...

Watched a video and like the idea. His hold downs need work as they allowed that short piece to lift up but that's so much safer. That said I wonder...

Rubber snakes seem to work well. I have birds landing on the mirrors of my cars and fighting with there own images and of course leaving skid marks...

Cast iron is nice for this, mine has not yet dampened vibration but it certainly does damp vibration. :D:D:D

All I have to say is that our NHL team is the Lightning. Can't be a coincidence.

I'm a cast iron fan and went with this purchased setup vs building my own in the interest of time.

In my commercial work I take great delight in making a drawer 1&1/2” deep if that is all that’s needed. The customer has usually never seen purpose...

Years ago, lightning hit our steel flag pole, which is about 30 feet shorter than the surrounding trees. It melted the shackle the held the pulley...

These are beautiful. Just... wow!

I have used 3/4 plywood for router tables. I used 1x3 around the hole and 2x4 ladder frame underneath to stiffen the sheet. It stayed flat. It was...

Yeah, speaking to the people at my local Woodcraft, delivery times on Festool, Laguna, and most big and small tools is off the charts now. Festool's...

PM sent ....

So an important question is where was the 36" pipe sourced? Mexico, Canada, Indonesia?

I use cast iron for mine, Julie, and even in our neck of the woods simple maintenance prevents rust issues. My issue with the one I have (in a...