Activity Stream

I'd try Robocopy rather than xcopy. Faster and likely more stable. I've used it for backups in the past of virtual machine files that are...

I guess they were getting ready to build a stretched version of that plane.

Thank you... I was wondering about that.

Yeah, right and today's F-150 is a "knock-off copy" of Henry Ford's Flat Bed Model-T. The Veritas planes are a vast improvement to a concept from...

I have learned to microwave the meat until it is close to cooked all the way through then grill it for flavor. My easy favorite is diced green...

A ring fence takes a bit more finess to use, but it very flexible. The shaft on the shaper should be machined to ISO h7 standards which can be...

I thought I would add to the confusion the term "Limited Category 1 and Quick-hitch compatible" Which (I think) means, I'm really a CAT 0 but I'm...

Hi Dan, yes you need a taller spindle, and there’s something wrong with the bearing, they are accurate however they just slide on. I presume you...

First check that the screws holding on the face are tight, and the face as square to the table as possible. Now check with a good straightedge, and...

That's a great (and inexpensive) idea! Thanks!

No frown intended. Thought it looked like a confused guy with 3 question marks above his head, which was me, trying to figure out how to use a...

If you are looking for flip stops for the crosscut fence, Proscale has direct bolt on options for MiniMax saws. I have a pair of them on my SC4E. ...

He's tied off too it looks like. Wise decision.

I looked into one a few years ago and decided against it for that reason. A forum I was looking at someone stated that they had two identical...

Gloss varnish has been rubbed out..table is DONE :D And will be heading out to the Gazebo...

I can get by using just the one....second one is because it's spurs/knickers are in place...first one doesn't have a way to use them anymore....hole...

Years ago “rub bearing “ was only used for non ball bearing (often shop made), wooden “bearings “….coated with bees wax. I’ve used them, but that...

A neighbor has a similar Robland saw (8') and is happy with it. I haven't used it but it looks to be on a par with my Paoloni and the MiniMax line...

Sou your recommendation would be to own 2 combination planes? Coincidentally I was thinking about finding a second combo plane, but not being a huge...

I've never needed to run a humidifier in the summer. Might be nice, actually!

Thanks for the detailed story Prashun. I was wondering how it happened. Pretty scary really. Seems you can’t be too cautious really.

I tried the Spyderco ceramic stones but really didn't like them. They're sitting in a cabinet somewhere. Maybe I should pull them out and try them...

Ah, I did find those CBN wheels for the WorkSharp - $50/each. I'll probably keep using the diamond ones I have for a while. Maybe when they wear...

That spider is out of this world awesome. The cutting boards are pretty sweet and that's a nice score on lumber!

Since I grind all my bevels, going to the stones is really just a few strokes to improve the cutting surface. For a touch up, I only make about 3...

Did you ever call your utility company? They could certify the lines up to your house and probably verify the connection at the house and might just...

The SORBY Sharpening System is SOLD!