Get rubber feet from McMaster Carr. They will accommodate about 1/16" of unlevelness. Add washers to get more, or use small pieces of peel and stick...
I tell them that I seem to spend most of my time doing finish work on my home. Jamb extensions, custom made casings, cabinetry, built-ins...but, I'd...
Nice miter shoot board...How is the far side, or opposite angle side used? Seems like it would result in a lot of blow out, or is the plane reversed...
Basically.. you mount a flat board, it spins and the ring master cuts rings out but the cut is slanted. When you have it dialed in, you can stack the...