Activity Stream

Monte, I do not have a WS, nevertheless what you are wanting to do - keep the primary bevel the same as the honing angle - strikes me as being very...

The really old way of fighting inflation was “sack - a - city “. High profit by “low overhead” Mel

Ronald, that looks like a pretty good deal, but I think Steve has indicated that his budget is more around $4000 or so. So probably out of his reach....

Does your slider have felt wipers like a Martin? What kind of bearings does it have? Some machines have rollers running on phenolic ways. Mine has...

I suppose inflation could be controlled by recession. Either way, regular people are screwed. Unless wages go up for regular people, they will fall...

That profile will work with either diameter head. For your future shopping awareness, some profiles will only work with the smaller head. The 55 wide...

There's a moment in any project where you wonder if it's all going to work. Amazingly, this one actually worked. Spoilers! Next up: hinge pockets...

try either one of these- Both are pretty much the same, used both over the years, been using the Novus for quite awhile as my old man bought a...

perpetual motion is easy if you have an electric motor to help ;)

Perpetual motion machines are fun to watch. It always makes me wonder on where is the magnet. jtk

Hmmmm, one of those came my way at an estate sale many years ago. This sounds like a great use for part of it. jtk

Just wondering , what KIND of analyst? I hope it isn’t a guy eagerly looking forward to getting HIS bales of new clean money ! Make sure he is...

In Richard's post above his last paragraph contains very wise words of wisdom. Mull over those words very carefully. My suggestion if you are...

thanks for opening, and you are correct it is not exactly what I need. thanks.

As a counterpoint, my 26" Moak saw has a direct drive 900 RPM motor (6100 FPM), factory original. I have no trouble. The Tannewitz manuals for...

I have a 8” Laguna jointer and I’m really happy with it. The fence stays perpendicular and the beds are dead flat. That said, the helical model is...

If you're trying to cut it on the table saw, you'll have to hold the pieces vertically. There's no way to get the blade to tilt far enough to...

Brent. Great info. Does a rebate cutter cut on top, bottom and outside face of the knives. I assume it does, just confirming. Do they make a guide...

Once inflation has been controlled, the Fed will drop interest rates. My analyst says early 2023.

We need pictures of this knife.....:D

That solved it for me too Robert. Thank you !!

I think of online reviews like Olympic scoring during the cold war. Throw out the high and low scores and average the rest. my favorite Consumer...

Hi Gary, the CC company will look after everything for you, and most folks in the US haven't even been charged duty or anything. They're using a...