Activity Stream

I can't make a Bailey chatter even with the lever cap not snapped down. When I pick one up, I'm not looking for something "to fix." Apparently I'm...

Good question. And I don't know the answer. But I suspicion that the reason is that because the veneer is so thin, it can't absorb much glue. ...

it does add a lot but also found its a lot more work and becomes costly materials and laser cutting can run around $144.00 and that's not painted...

oof. I'd hate to find that out by touching a grounded case.

The key point about why Derek made this modification to his mobility solution for the jointer/thicknesser was to provide easy movement in all...

have fitted 2 more of the...halfway there...maybe tomorrow, I can get the other 3 done...have to go and edit a few photos...Film @ 2300 hrs..

The chip breaker/cap iron, in Bailey's patent, was also claimed to be designed to facilitate using a thinner iron to counteract chatter. Changing...

This is sold and shipped. Thanks.

I didn’t mean to Jinx Derek. I have a green pallet jack my heaviest machine is 1900#. I’ve had to move my bandsaw once to rip long slabs it’s...

"I wanted a thicker iron..." A huge percentage of the Bailey design was specifically formed around using a thinner iron than was common at the...

different levels of pallet jacks and heavy duty weight goes up. I think 300 lbs for the heavy duty ones and capacity over 10,000 lbs instead of the...

Wow! Cool (& useful) stuff i never thought about - thanks for posting. smt

I'm not the one who brought up being board. If something bores me, it is time to get up and do something else. I like what Mark Twain said in...

There is another aspect of the #55 in it is easier to make stopped cuts and cuts on corners or chamfers. The #55 has an extra screw, located...

As you are doing now?

When I worked for Glidden paint, they had a corporate training center in Rocky River Ohio. I was lucky enough to attend a few seminars there. One,...

Often a boring situation will wither away if those finding it boring simply ignore it. Offering bits of sustenance only prolongs an ever so slow...

You may have had insulation damage to the line conductor caused by lightning, which in many cases is not detected by a conventional multimeter. ...

I don't understand why you get so worked up about what I post. Nowhere in what I write do I say what I do is better than anything else and everyone...

I have 2 Stanley No. 45s....one set up for across the grain only, the other set up for with the grain...A Type 4 and a Type 20 SW

So....Last of the grooves are done, for now... Rail & Stiles need a 1/4" tenon milled.. Yes, just a 1/4" deep...as other spots will re-inforce...

The dream is to have the space where mobility isnt needed or at least enough so storing a pallet jack isnt an issue. In the future you can rent...

Not in the slightest.LOLOLOLOLOL!!!!! Says the fellow that can't even spell Sensei (Teacher) correctly..besides, I am too busy laughing at your...

Ok interesting. Yep, same shroud setup on infeed side as well. Hope you get the saw up and running soon!

Saw #1 is sold. Thanks Larry!!

Hi Andrew, tens of thousands of Felder and Hammer customers world wide move their machines without incident. In my case it’s been 16 years. ...

havent listened to them so far. Rather a you tube, I see the equipment and often an indicator of what we will see. Id rather see their equipment...

It did not, however that is the original arbor nut and flange as far as I can tell. It differs from the later version you have. I see I'm also...

Jared, did your saw come with a dado arbor extension? I’m just curious about the arbor nut on your saw in the picture.