Activity Stream

Like most things when it comes to woodworking there's no shortage of different ways to make a project. I'm always adjusting the infeed table. I...

the drill press has a stop time of 1 second and have had no issues with it. On the table saw, I'm at 4 seconds, and it works well with both fulll...

I've never sanded PVC, and must have put together over a thousand joints since I got my Plumbing license in 1975. The primer cleans the pipe good...

Looks like I need to stop by to check it out! What’s that new buffer or grinder next to the tormek? Hope all is well, great seeing about beautiful...

Thank you both for the advice. There is no water getting out upstairs, or running down the side of the coupler, so wherever the water is coming from...

When the chips are down …don’t count them , or weigh them ! Faster to just sweep them up ! One of the little known woodworking secrets that...

I always sand both mating surfaces with ~80-120grit. Then apply the primer once or twice before welding with the cement. The larger the...

White oak cut into very thin laminations. Agree that a rigid urea formaldehyde glue will be needed. Wear a good mask. Also agree you’ll need to do...

I typically get parts from a local dealer i find that to be easier.

Awesome! Thanks for the feedback, I aim to please. :)

Why wouldn't he read and post here. There are more Grizzly disciples here than any place on earth. Sometimes I get the feeling he has a stake in...

It won't feel slippery, more like silky. Your hand will glide over a rubbed out handrail, but won't slip if you grab it. If you prefer no wax use a...

Check the tank to toilet seal, the water supply to tank and the toilet to flange connections. Have you checked for puddles behind the toilet under...

Thanks Derek, I'll take another look....

As I understand it, Doug made his first bowl gouges for himself to suit himself. I don't know, but surmise that he experimented with different flute...

Personally, I wouldn't want anything approaching "slippery" on a handrail...

I find going up to a 1.5mm tip worked better for me with the 6500.

Steve, did you speak with them on the phone? That's often a good idea with Harvey. The stacked shipping may be a web site thing and a whole order on...

What John said. I'm about to spray the Emerald Urethane on my "scrap vanity" project and have used Advance in the past during one of the...

I like that I can put stuff above it in the new shop...which is where the compressor is going to live. :) There will be a deck about four feet of...

Thank-you sir, you are too kind.

Almost all my planes are LN, but that’s exactly why I purchased the RH version. At first I was disappointed - I had trouble fine tuning the...