The switch is just on-off for the machine? That's it? How much power goes through it, and what would happen if you just jumped out the switch with a fused jumper with wire heavy enough to carry the load?
Contributor
The switch is just on-off for the machine? That's it? How much power goes through it, and what would happen if you just jumped out the switch with a fused jumper with wire heavy enough to carry the load?
Retired Guy- Central Iowa.HVAC/R , Cloudray Galvo Fiber , -Windows 10
[OP]
Member
No, the switch just diverts the power from the Y stepper motor to the rotary stepper motor. I haven't used it in a couple of years but find it odd that the terminals and wires are fried. I disconnected the M21 and M22 wires from the Y controller to see if anything changed....dead still.Originally Posted by Bill George
Last edited by Joseph Shawa; 01-13-2018 at 1:03 AM.
Chinese 6040 by NiceCut. Originally 60 Watt upgraded to 150 Watt.....I thought I had pretty much every problem in the book of laser cutting. It turns out that there is a set of books.
Posting Permissions
Reply With Quote