I had to have LaserCut reinstalled on my computer and now I'm having an issue when I send my job to the laser. From the very first time I used the software and laser I could place my substrate on the laser bed, move the laser head to the position where I place it, run my box so I know I'm where I need to be and then press go.
After install, I do the same steps, but when I run my box it goes all way back to the top right and then runs the box. I just want to be able to put the laser head exactly where I want it and it start from there. I'm sure there's an easy answer, but since I didn't set it up either time I don't know where to change it. Any help would be greatly appreciated.
Thanks ya'll!!