Results 1 to 4 of 4

Thread: Log to BF calculator

  1. #1

    Log to BF calculator

    I’ve posted about this before but I have actual measurements now. I have a 1/3 acre lot about 20 miles north of I-20 and 20 miles east of the Savannah River (for geographical reference). I measured 50 yellow pines on this lot yesterday, about 4 feet up, and on average, being VERY conservative, they are 18inches in diameter (not counting the bark) and about 35 feet long. They’re closer to 50-60 feet long but they’re all pretty consistently 18 inches thick to about 35 feet. I used the calculator at wood web and it came out to a little over 21,000 board feet. Does that seem right? Seems like a bunch to me.

    The actual measurements came out to almost 72000 board feet. That was the diameter including the bark and actual lengths of each tree. The 21000 is minus 10 inches in diameter and the average length ( estimated). That seems like a HEAPING pile of lumber from 1/3 of an acre. Is it possible??

  2. #2
    Join Date
    Dec 2010
    Location
    WNY
    Posts
    9,838
    I get 21,450 bf using the Doyle scale for 50 logs at 18" at the small end and 35 ft long. Yep, lotta lumber, but if your trees are that size, that's what you'll get, possibly more because the Doyle scale is biased low for smaller diameter logs. For example, if you use the International Scale, it will yield more than 29,000 bf. I use the International 1/4" scale for my bandsaw mill and it's pretty close. In any case, you have a lot of lumber standing there.

    John

  3. Based on your measurements and calculations, your estimate of 21,000 board feet for 50 yellow pines on a 1/3 acre lot, with an average diameter of 18 inches (excluding bark) and a consistent height of 35 feet, might be conservative. Recalculating with these dimensions suggests approximately 37,086 board feet, while considering the full lengths and bark can push this to around 53,016 board feet. Therefore, while 21,000 board feet may be an underestimate and 72,000 board feet an overestimate, a more realistic range would be between 30,000 to 53,000 board feet, confirming a substantial amount of lumber from such a lot.


    ____________________
    https://zdrowypakiet.pl/

  4. #4
    Join Date
    Nov 2021
    Location
    Mid West and North East USA
    Posts
    3,128
    Blog Entries
    3
    Quote Originally Posted by Bobby Hunt View Post
    That seems like a HEAPING pile of lumber from 1/3 of an acre. Is it possible??
    This is why SYP is such an important producer. Your 1/3 acer has been managed well! Congratulations!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •