First major shot out to Ray and his team. Got me out of some bad config settings, major issue with the Y axis.
Second I'm running as mentioned before a Rabbit Laser 80 1290, RDc6442G controller, latest version of RDWorks V8.01.60
Now the currents issue I'm having is that I can set the Z axis just fine, but for some reason I set origin, but then I hit 'Start" and it lasers some where else on the bed. In addition my laser pointer red dot is not showing up.
I just got this laser from I guy I'm working with, I was running his Universal Laser 660 for a few months until the CO2 tube ran out of gas. So im little familiar with some of this, but the Rabbit is different then before. TY!