Hello all, this has probably been asked before but looking for a fresh set of opinions.
I am using this primarily on Baltic birch ply and hardwoods, and for just flush trimming and pattern applications. Ideally I'd like to get a decent sized one with top and bottom bearings. In the past I have used several less expensive bits mostly straight cutter from Freud. This past year I bought a couple of the infinity mega flush trim bits and was very disappointed (more on that another time) in short on the ply they were leaving grooving consistent with the plys themselves... very odd and they didn't have an answer and eventually took them back and couldn't find an issue. I'm sure I'm not the only person using these on bb so it was odd. I use these primarily with a dewalt 618 2.25hp router bit in the table and by hand.
Need something that cuts nice and smooth with clean edges on ply. And can remove a decent cut from time to time, though usually not more than 1/16th.
What are you all using? Thanks!