I have a brand new Veritas Carcass crosscut saw and it seems to want to drift about 1/6"+ in 5 inches. I'm no expert at sawing and probably need some practice but, it's a new saw, I'm gripping as light as I can. The wood is 2" x 5" maple butcher block I'm cutting for my tail vise. I start by cutting across the edge with the edge up in the vise and then start dropping my hand and attempt to follow the line on the face. I expected better. Maybe I should start with the wood flat in the vise and just start on the far edge, I don't know what's right. I would like better results.