Hello new guy here
I did a total rebuild on a Yates 18” wedge bed planer that’s the same as the delta style wedge bed planer and I had it all apart and now I’m at the point that I will be installing the cutter head but the left and right side are parallel to each other but are misaligned from each other by more than .075
If I remove the front casting that holds both half’s together I can move it to within .04 but that’s about it
My concern is that I will not be able to assemble the cutter head due to this issue any thoughts or recommendations?
I’ve been a member on OWWM for years and have had my rebuild post on there for awhile now and have had little or no luck getting any answers to my questions.
OWWM post below
https://owwm.org/viewtopic.php?f=1&t=220663
Any help would be appreciated
Thanks New Guy
Mike