My Sjöbergs Elite 2000 workbench arrived this afternoon. The workbench arrived in two cartons and the cabinet insert was in a third carton. I moved everything to the basement except for the worktop, and assembled the frame. The frame went together in about ten minutes. The uprights are already assembled, so it was a simple matter of gluing the dowels into the stringers, attach then to the uprights, and install the four bolts and captive nuts. I didn't glue the dowels into the uprights in case I want to disassemble it.
I waited for a friend to arrive so we could take the worktop down the stairs. It weighs at least 200 pounds and was not fun to move. The uprights have one large dowel each that mates with the front edge of the worktop and gravity does the rest. The worktop is not fastened to the uprights and the only connection are the two large dowels. The worktop was pre-assembled with the two vices, but the front vice can be moved to the other side of the table for a right-hand configuration.
The optional cabinet is a flat pack design and rests snugly between the uprights and stringers. There are four cleats (on the cable duct) that attach to the top of the cabinet and lock it into place between the top stringers. Unfortunately, there is no mention of this in the workbench instructions, and I didn't see it until I started assembling the cabinet. I have to wait until later this week for my friend to come back so we can lift the worktop off, screw in the cleats, and put the worktop back on.
Overall, I am very happy with this workbench. It came with four 1-inch bench dogs, but there are other clamps available separately. I have to figure out where the bench will eventually be, as I have to shuffle some of my equipment around. The flexible hose and power cable to the left of the bench go to the Minimax SC2. To the right of the bench is a Jet JSG-96 disc/belt sander that will be moved to a new space.