I just recently invested what I consider a pretty decent chunk of money into the whole incra Combo Number 3 router table with ls positioner and so far my only complaint is that the fense feels a little rough and makes a lot of noise. Considering the price of it everytime I hear that noise I can just picture the fence digging big trenches into the table even though I know that is not the case. Also small pieces keep catching on the router plate and ring with all the cutouts for the incra Clean Sweep dust setup no matter how hard I try to make sure it is perfectly level. as much as I hate to blame equipment when I know I am inexperienced, I think I have probably spent about three and a half hours on and off trying to make sure the plate was level but I am starting to think it just isn't flat.
Anyway the question is what can I use to lube the table up without destroying the table or causing issues when trying to finish the wood? The instructional video for incra said wax but it did not say What type and I am hesitant to just guess