I'll probably be posting several questions here over the next week or two as I set up a new-from-the-factory CU300.
After some cajoling with a two by four (tip from salesman) I finally got the shaper spindle to move up and down. I can't get the shaper spindle below the table bed with all of the spacers and bolts on.
1) Am I supposed to remove the spacers and the bolt on top of the spindle when I am not using the shaper, or is the shaper spindle bottoming out earlier than it should?
Picture somehow was rotated 90 degrees clockwise after upload....
shaper spndle height 3.jpg