I am looking for advise on several subjects related to a first time milling project. Let me set the stage and then ask the questions, thanks for taking the time to absorb this.
We lost a tree on our property in a storm several weeks back, there was a lot of damage but we want to look for a silver lining in the event and salvage some wood for future sentimental projects.
The arborist has cleaned up the sad mess and I had him leave several sections for me to get milled into lumber, I picked out anything that looked interesting. Now I may end up with a bunch of plain looking maple in the end but will take the risk, and I have no idea what I will make the lumber.
Let me set the stage for my resources.
- The logs consist of 2 pcs 10ft x 20", 5 pcs 2 1/2ft x 14", 1 piece 5ft x 14", 1 pc 10ft x 10", 1pc 10ft by 8". By Doyes method I may have 500-580 bd/ft but I'm not betting a nickel on the calculation.
- I'm considering milling live edge slabs (2" finish thickness) from some of the larger logs and perhaps 3/4" or 1" finish from the shorts and thinner pieces, see my questions on what size to cut to end up with these sizes.
- The Sawyer has a portable bandsaw type mill, said it is a minimum size 4hr job with travel plus $50 for blades if he hits steel. I do not know if the sawyer will even cut the shorts
- I have a backup plan to use a Granberg mark iii sawmill along with my Echo CS590 Timber wolf 20" although I will need a larger 28" bar and chain for some of the pieces. I plan to first cut one or two shorts with the granberg system just for personal experience and also to get an ide of what the lumber might look like. I am not sure if I want to try chainsaw milling the 10ft pieces.
- getting some personal experience is a big plus to me, I like to try new things but I don't want to bite off too much.
- I have no means to graceful move the 5-10 ft pieces so I would saw them in-place or rely on ingenuous mechanics to move them; in my later years my back looks to my brain to do lifting ;-) The Sawyer does have the means to handle the material.
- My ultimate backup plan is to cut it all into firewood lengths and give it away, but that would be sad.
- One last thing, I am in Canada, spring weather is late with maple sap running late this year.
So onto the various sawmilling questions, your comments/suggestions/experience
on any of the following would be greatly appreciated
1) Using the Granberg chainsaw mill for this project, ripping vs regular chain,
best ladder setup for first cut, using the echo 59cc saw, etc.
2) Should I debark before or after, if I go the chainsaw route, methods of
debarking?
3) Using a sawyer for the job, my biggest concern is my cost getting out of
hand, there is a limit to sentimental value :-)
4) What thickness do I rip at? i.e. if I want to end up with finish planed 3/4
should I cut at 4/4 or 5/4 or? same question if I want a finish planed 8/4?
5) Times for drying, air vs kiln, vs combination, the process, etc.,
6) Methods to dry, sticker, etc.
7) any ingenious methods to manhandle the logs with less muscle?
8) safety suggestions (should be the first question)
9) and the fun question, what would you make with this wood?
Thanks