A grizzly g1021 planer has landed on the garage floor. This thing was a beast to move. Paid $250 for it. It does have some (well, a nice coat of) rust on the the table that needs to be taken care of, leaked some oil during the move , but other than that I just have to reinstall the dust hood (previous owner didn't have a dc) and the rollers and should be good to go. I got the spare blades that have been unused, setting jig, and manual too.

for those that need proof:

On to the rust. Searching the creek showed a rust removal job using conditioning belts on a belt sander. Has anybody else done this? Looked like a good job, but not as bad of a starting point. http://www.sawmillcreek.org/showthre...ditioning+belt Or is 400 grit/mineral spirits/elbow grease the way to go? I would need a pretty big tub for the electrolysis method

Thanks,
Mike