Chainsaw starting/storage question

[tom lucas]

My $0.02. First and most important, if ethanol is in your gas, dump it and find non ethanol gas. I personally do not believe in those gas additives that stabilize and neutralize ethanol gas. Ethanol and water from the air creates acids in the gas that dissolve the rubber in your carb. If you're not going to use the saw for a while, dump the gas in the tank back into your gas can, start the saw and run all the gas from the carb. Gas goes stale and turns gummy. There are tiny tiny passages in the carb that get get clogged up.

I've been using startron additive for about 14 years now. I have 12 gasoline machines. some 2-stroke some 4. All of them start and run great. I never drain the carbs. But I treat 100% of my fuel with startron. Swear by it. It really works. Some of my machines might not get started for nearly 2 years sometimes. When I pull them out, with the old gas, they just start on first or second pull and purr with no issues. Don't waste your money on that expensive ethanol-free fuel. Just put startron in and forget about it. Now if you've already let ethanol ruin a carb, you'll have to deal with that first. Though startron can "repair" some pulsating, over time if not too bad.

Seafoam can help restore carb function too. As will half a can of carb cleaner mixed in the fuel tank. But there is no easy cure for a badly gummed carb or damaged float.