I have mainly only done wood turning. Pen sets, bowls, etc. I am wanting to start into flat work but would like information
on what is the best route to take the wood through. What I mean is cut, plane, sand in what order and fashion.
I have a table saw, 16/32 open ended sander, 13 inch planer, 8 inch jointer, hand held orbital sanders, routers. Also what steps are most doing
when it comes to a (for example sake) an hour glass, I mean do you turn and cut all pieces and then finish each piece then put together or ???
I have not had any formal training but have just been messing around with wood but now I am wanting to get serious with the hobby and try not to make goofy mistakes. Yes I do know that mistakes are a part of learning however.
I do appreciate any and all positive feedback.