I'll probably be posting several questions here over the next week or two as I set up a new-from-the-factory CU300.
After some cajoling with a two by four (tip from salesman) I finally got the shaper spindle to move up and down. I can't get the shaper spindle below the table bed with all of the spacers and bolts on.
1) Am I supposed to remove the spacers and the bolt on top of the spindle when I am not using the shaper, or is the shaper spindle bottoming out earlier than it should?
Picture somehow was rotated 90 degrees clockwise after upload....
shaper spndle height 3.jpg
Reply With Quote