Hi,
I am reading thread by Carol VanArnam in the Laser Engraving Forum and am unable to locate and read posts 41 thru 45. I can only go as far as page 3 posts 31 thru 40. What am I missing?
Thanks .... Frank
Hi,
I am reading thread by Carol VanArnam in the Laser Engraving Forum and am unable to locate and read posts 41 thru 45. I can only go as far as page 3 posts 31 thru 40. What am I missing?
Thanks .... Frank
Epilog Helix 35W, Corel Draw 12
Frank,
A link to the thread would be helpful.
.
Kieth,
Here is the link to Carol's thread....
http://www.sawmillcreek.org/showthread.php?t=59229
Thanks .... Frank
Epilog Helix 35W, Corel Draw 12
I have my preferences set on 30 posts per page, and all 45 show up for me. Not sure why you can't get to page 3. I'm guessing you have your's set on 20 per page. But that shouldn't be a problem. Jim.
Coolmeadow Setters...Exclusively Irish! When Irish Eyes are smiling....They're usually up to something!!
Home of Irish Setter Rescue of North Texas.
No, I'm not an electrician. Any information I share is purely what I would do myself. If in doubt, hire an electrician!
Member of the G0691 fan club!
At a minimum, I'm Pentatoxic...Most likely I'm a Pentaholic. There seems to be no known cure. Pentatonix, winners of The Sing Off, s3.
Do you see a more reply's below current depth box? What happens when you click on it? (I found this to be an issue for me early on, never knew there were any settings for it)
Frank,
I just checked the thread and it seems to be fine. I am at a loss what to tell you other than try hitting refresh in your browser.
.
Keith,
I just checked the thread after reading your post, there is now a page four and I can read it all....just don't know why it wasn't there before?
Frank
Epilog Helix 35W, Corel Draw 12