So..set up a Drafting Table, of sorts...
May Project, The Plan, Drawing Board.jpg
And, since the edge and the bevel are square to each other...
May Project, The Plan, layout work, parts.jpg
Made a nice drafting square...the 3-1/2 sections (8) are Raised panels...
Then a bit of Math 101...
May Project, The Plan, doing the Math.jpg
Wanting to know how long to make a few cuts...and then selected a trio of planks to haul to the shop..
May Project, start up, 1st 3 selected.jpg
Straight grain, quarter sawn Ash...
May Project, start up, face grain.jpg
But, there were a few issues..
May Project, Start up, too short.jpg
Like a few splits...
First cross cuts were done..
May Project, Start up, 1st cross cuts.jpg
So, next episode will involve a lot of rip cuts
Stay tuned...
Reply With Quote