Was working on feet for the case to sit on...Miter saw cuts..
Chisel Case, Lid & Feet, GEM Mitre box.jpg
Were having an issue...when a part is 1/4" x 1/4" square...and the back corner that meets the fence on a folding Mitrebox...
Chisel Case, feet, mitersaw issues.jpg
Has a round-over..small parts can ( and did) roll backwards a bit, into the gap...not an issue with 90 degree cuts...but with a 45 degree sort of cut, it becomes angled...decided to put the GEM away, and continue with the bandsaw..
Chisel Case, feet, ready for glue up.jpg
Will sort through this mess, tomorrow...to find the best 4 to glue up as feet for under the case...always nice to have a few spares handy...

Hinges:
Chisel Case, lid work, the hinges.jpg
Had a "flaw" at least for me...so...this was used to correct that flaw..
Chisel Case, Metal work, Monarch Vise.jpg
And the flaw?
Chisel Case, Metal work, the before.jpg
Note the gap back by the barrel? We have ways...
Chisel Case, Metal work, leaves flattened.jpg
Pinch it in the Monarch Vise, once per side..hammer adjust for any bends going on...

Need to do a bit of layout work, before these tools can do their thing..
Chisel Case, lid work, tools and screws.jpg
Stay tuned...