Ok...those clamps came off this morning...back was cleaned up..
Chisel Case, drawer work, back cleaned up.jpg
Followed by both ends, and then the front..
Chisel Case, drawer work, front cleaned up.jpg
And the top edges leveled...then the bottom was leveled...
Chisel Case, drawer work, level the bottom.jpg
As some of the rebate edges were a hair proud of the panel

Was able to do a test fit..
Chisel Case, drawer work, test fit.jpg
But, until a knob was installed, didn't feel like push it all the way in...

A support was added to the inside of the drawer...
Chisel Case, drawer work, seeing what fits.jpg
Then laid out the diagonals, to find the center of the drawer front..
Chisel Case, drawer work, cordless drill.jpg
A cordless drill was used. A Mini Shaker Peg was modified to fit....
And NOW I can push the drawer in as far as it can go...
Chisel Case, drawer work, knob done.jpg
Maybe tomorrow, I can work on that lid a bit?

Stay tuned..