I always stress about the proper procedure when I am gluing up a project with a lot of joints. See picture of one side panel below. I have a face frame that I am also going to attach using biscuits and glue. So I need to glue the face frame on and attach the four back horizontal pieces all during the open time of the glue. I prefer using Titebond III, the green bottle never had a problem with it, except table tops and switched to the blue stuff for that.
I thought to put the face frame and sides on with slight clamp pressure front to back, then gently insert the back horizontal pieces, lightly clamp, square up and hand tighten clamps.
Appreciate if there is a more efficient way to go about this.
Brian
20240203_120959.jpg