Results 1 to 9 of 9

Thread: Hollow Form Interior Surface Finish?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 12-06-2023, 4:36 PM #1
    Neil Strong's Avatar
    Neil Strong
    Neil Strong is offline Contributor
    Join Date
    Apr 2010
    Location
    Adelaide Hills, Australia
    Posts
    389
    Quote Originally Posted by Brice Rogers View Post
    Also, I don't spend very much time sanding deeper than a person's finger can go.
    ===> Ditto!
    Neil

    About the same distance from most of you heading East or West.

    It's easy to see the Dunning-Kruger Effect in others, but a bit of a conundrum when it comes to yourself...


    Reply With Quote Reply With Quote
  3. 12-06-2023, 9:49 PM #2
    Steve Nix
    Steve Nix is offline Contributor
    Join Date
    Jul 2015
    Location
    Southwest Louisiana
    Posts
    156
    AZ Carbide teardrop scrapper are the best I’ve used on an articulating hollowing device.
    Reply With Quote Reply With Quote
  4. 12-07-2023, 9:01 AM #3
    Peter Blair's Avatar
    Peter Blair
    Peter Blair is offline Contributor
    Join Date
    Jul 2011
    Location
    Delta BC
    Posts
    1,341
    Here are a few photos of what I made up to sand inside hollow forms as long as the opening is larger than 1 1/2". I often also use them on vase shapes. It has a handle that is about 16" long.The rounded end does a nice job of the bottom.
    .IMG_9228.jpgIMG_9229.jpgIMG_9227.jpg
    Pete


    * It's better to be a lion for a day than a sheep for life - Sister Elizabeth Kenny *
    I think this equates nicely to wood turning as well . . . . .
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules