Page 3 of 3 FirstFirst 123
Results 31 to 33 of 33

Thread: Weird tracksaw precision

  1. 01-19-2023, 1:29 PM #31
    James Jayko
    James Jayko is offline Contributor
    Join Date
    Nov 2015
    Location
    Philadelphia, PA
    Posts
    402
    I would think if it were the saw, it would be consistently off by a specific amount over a specific distance, no? Like, out by 1/8" over 3'.
    Reply With Quote Reply With Quote
  2. 01-19-2023, 1:34 PM #32
    andrew whicker's Avatar
    andrew whicker
    andrew whicker is offline Contributor
    Join Date
    Oct 2016
    Location
    Ogden, UT
    Posts
    1,701
    Blog Entries
    1
    A) that would be a strange scenario
    B) you can just do the math on a calculator real quick to get you close to what you want to see on a fractional tape and verify it w/ the X measurements.
    C) As said above, you can also just measure two parallel sides and if they are good AND your X measurement is good, then life is good.
    Reply With Quote Reply With Quote
  3. 01-19-2023, 4:30 PM #33
    Mike Hollingsworth's Avatar
    Mike Hollingsworth
    Mike Hollingsworth is offline Member
    Join Date
    Oct 2005
    Location
    Pasadino, CA
    Posts
    920
    https://www.amazon.com/dp/B0B8BQH9RB...dDbGljaz10cnVl

    great item to make 90 degree cuts on a track saw
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules