I have a Phasae Perfect 20hp unit hooked up to an 80 amp circuit breaker. I routinely run my 5.5 HP dust collector along with my Martin T60 which I believe is also 5 hp and occasionally my 7.5hp j/p by Minimax or Felder XFormat shaper at the same time with no issues.
I am very careful never to exceed the total HP on the unit.
I am looking into a new CNC machine and would like to get the largest vac pump I can, which are 3 ph. Knowing that my ALKO 200 has a 5.5 hp motor would I be able to run a 15hp vacuum pump? Or should I stick with the 10hp version?
Does 20hp PP unit allow a full 20 hp to be used or should I be conservative?