A little background info (and keep in mind that I’m just a wanna be woodworker).
I’ve been searching (with no luck) on how to best make the roundover on a 2”x6”x16’ oak handrail (its very heavy)
I purchased a grizzly C153h5 router bit for my 3-1/4 hp router. But after receiving it the box says max 12,500 rpm (web site said 24,000 rpm). My PC isn’t a variable speed router.
So I ordered a collet spindle for my little 1-1/2hp g1035 shaper. I made a taller fence for it thinking I could tilt my baby feeder 90 degrees and run it against the vertical (6”) handrail. But now that little voice inside me is telling me not a good idea.
Rethinking it I am now considering either an additional tall board fence and clamp. And using the baby feed like I normally
Or maybe a stackable feather board.
Or make this an excuse to own a new router!
I also purchased a C1584 finger groove bit that I was going to use first before the round over.
I have 4 rigid flip top feed supports and 4 roller style supports that I was planning on using with the shaper.