For those of you that are within a few hours of DeQueen, AR (40 minutes from my shop):

Hamel Plywood buys culled plywood from Columbia and random stock from places where their stock becomes outdated as government contracts change. Don't think of culled plywood as a bad thing either. Some of the defects are so ridiculous I can't imagine it being listed as a cull: but good for me/us.

Every 3/4x4x8 sheet, regardless of veneer is $32/sheet
Stacks of QSWO with Maple A1 backs.
Stacks of Red Oak QS with Maple A1 backs.
Rotary cut RO2S
Pine
Alder
Birch

Every 5/8x4x8 is $25!!!

Every 1/2x4x8 is $12!!!

Every 1/4x4x8 is $8!!!

To give a little perspective. I've been paying $110 for QSWO single sided. $75 for RO Rotary. $10 for 1/4 MDF.

I picked up 13 sheets of 1/2x4x8, prepainted on both sides (feels and looks like melamine) for my shop-side office and paint room walls for $12. Perspective? I outfitted my interior paint room with 7/16 OSB and it took 4 gallons of primer and 4 gallons of enamel - cost me about $400 all together. The sheets for the exterior cost me $187. Only one side had defects in the paint - and for a shop those defects were laughable.

Anywho... w00t!